Inquiry
Form loading...
Products Categories
Featured Products

WiFi HaLow diagram integrated long-distance transmission 802.11AH low-frequency module drone robot diagram transmission

● Based on IEEE802.11ah (Halow) protocol
● Data throughput 16Mbps
● 1 km transmission distance throughput is greater than 1Mbps
● Supports multiple interfaces: SDIO/USB/ serial port/network port
● Excellent diffraction capability
● Applicable to: wireless package; baby monitor video surveillance; Drones;
● Robot industrial control; Internet of Things; Smart wear

    Product Specifications and Parameters

    Category Parameter Note
    RF Protocol IEEE 802.11ah
    Frequency range 902MHz-928MHz
    BW 8MHz
    Data rate 16Mbps/up to 16Mbps
    Sensitivity 1M PPDU MCS=10 -105dbm;8M PPDU MCS=0 -95dbm;8M PPDU MCS=7 -81dbm
    STA count up to 31STA
    Tx Power 20dBm 100mW
    Modulation BPSK,QPSK,QAM16 or QAM64
    Transmit distance LOS up to 1Km;non-LOS up to 500m
    Hardware Security WPA2-PSK
    Encryption mode AES
    Ethernet 10/100Mbps
    UART TTL Level
    UART Baudrate Default 115200
    Power DC5V1A/12V1A
    LED indication Power LED
    Mode(AP/STA) LED
    Signal LEDs
    Antenna Jack IPEX
    Electrical performance Power Input 5V1A/12V1A
    Maximum current 500mA
    Power consumption 1.5 watts
    Working Temp. -20 ℃ ~ 70 ℃
    Storage Temp. -30 ℃ ~ 80 ℃
    Working Humidity 10%~90%
    Storage Humidity 5%~95%
    Antenna Type External Omni-directional antenna
    Length 19cm
    Size Product Size 38x38x2mm(excluding antenna)
    Weight  38g

    Module Interface Definition

    XQ1cy5

    Module Structure Diagram

    xq2o54

    Operation Guide

    1. Connect one end of the IPEX converting SMA cable to the IPEX, and connect the other end to the antenna
    2. Switch the mode switch of one module to the AP (receive) position and the mode switch of the other module to the STA (transmit) position
    3. After the module is powered on, the five working indicators will flash for self-test. After the self-test is completed, the red power indicator of the module in AP state and the first indicator on the left will be long on, while the red power indicator of the module in STA state is only on
    4. Press the pairing button at the same time, then the signal indicator light of AP module and STA module will blink, indicating that the pairing is successful, release the pairing button, the signal indicator light of the two modules is long, and the module can be used normally

    Product Application

    xq4ob8xq5kes